If you still cannot get the engine to start, have all your testing information ready for a technician prior calling. Twisting wires together or taping wires will cause engine inoperability. Make sure you carefully solder the connections. Ensure the wires CANNOT TOUCH THE FLYWHEEL! (especially on the inside of the flywheel) Twisting wires together or taping wires will cause engine inoperability.ģ) Is fresh fuel in the gas tank? If you still cannot get the engine to start, have all your testing information ready for a technician prior calling. If the engine still does not start, and before calling technical support, performs a few basic tests:ġ) Re-check the connections. Swap the connections, re-solder the wires and the engine should start. Step 10: Fit the ignition cover.Įngine will not start: Sometimes the source coil wires are reversed. Ensure the wires CANNOT TOUCH THE FLYWHEEL! (especially on the inside of the flywheel) Step 9: Refit the flywheel. Step 7: Mount the coil onto the baseplate, fit the screws using locking compound on the threads and TIGHTEN THE SCREWS SECURELY! (the type used in electrical applications Use a soldering iron and resin core solder. Take a good look at how the wire is connected to the coil.Ĭonnections: Connect the old wire up to the new coil. Step 6: Cut the original wire close to the original coil. Step 5: Remove the screws that secure the coil and take the coil off. Step 4: Remove the baseplate with the original coil. Step 3: Remove the flywheel using a proper puller tool. Step 2 :Take note of the wire colors of the original stator wires and disconnect them from the wiring loom. The remplacement part should match, including the mounting hole locations, If not: Double check the application listing with your bike. 3 wheeler, Three Wheeler, ATC 1 (Prior Lake) 0 Oct 21 Honda atc 110, 125m, 185. Are the remplacement parts similar?Ĭompare the replacement part to the original. 3L F23A VTEC SOHC MOTOR ONLY 1998-2002 699 (Garland) 699 Oct 26. Read these instructions completely before beginning: Step 1 : Take the ignition cover off.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |